Een MTS schroefset met Eibach veren, geschikt voor de Audi TT 8N Coupe 8N3 1.8T Quattro / 3.2 Quattro
Street variant
De ophanging van de Street-serie is de standaardconfiguratie van MTS Technik-ingenieurs, het garandeert een breed scala aan verlagingen en een balans tussen comfort en stijfheid.
Verlaging voorzijde: van 25 tot 50 mm
Verlaging achterzijde: van 25 tot 50 mm
Maximaal belasting (voor):1050 kg
Maximaal belasting (achter):1080 kg
Geschikt voor:10/98 - 09/06
Let op:
Front and rear axle height adjustable (threaded shock absorber housing on the front, dampers, springs and height adjustable elements on the rear).
Stabilizer bars may need to be changed with longer ones if lowering more than 40mm.
If the right drive shaft diameter of more than 42 mm, the maximum lowering mentioned in the catalogue is reduced by 15 mm.
If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.
During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers.
Een MTS schroefset met Eibach veren, geschikt voor de Audi TT 8N Coupe 8N3 1.8T Quattro / 3.2 Quattro
Street variant
De ophanging van de Street-serie is de standaardconfiguratie van MTS Technik-ingenieurs, het garandeert een breed scala aan verlagingen en een balans tussen comfort en stijfheid.
Verlaging voorzijde: van 25 tot 50 mm
Verlaging achterzijde: van 25 tot 50 mm
Maximaal belasting (voor):1050 kg
Maximaal belasting (achter):1080 kg
Geschikt voor:10/98 - 09/06
Let op:
Front and rear axle height adjustable (threaded shock absorber housing on the front, dampers, springs and height adjustable elements on the rear).
Stabilizer bars may need to be changed with longer ones if lowering more than 40mm.
If the right drive shaft diameter of more than 42 mm, the maximum lowering mentioned in the catalogue is reduced by 15 mm.
If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.
During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers.
