Een MTS schroefset met Eibach veren, geschikt voor de Audi A8 D2 4D2/4D8 2.8 / 3.7 / 2.5TDI
Street variant
De ophanging van de Street-serie is de standaardconfiguratie van MTS Technik-ingenieurs, het garandeert een breed scala aan verlagingen en een balans tussen comfort en stijfheid.
Verlaging voorzijde: van 10 tot 60 mm
Verlaging achterzijde: van 10 tot 30 mm
Maximaal belasting (voor):1380 kg
Maximaal belasting (achter):1230 kg
Geschikt voor:03/94 - 12/02
Let op:
Front and rear axle height adjustable (threaded shock absorber housing on the front, dampers, springs and height adjustable elements on the rear).
If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.
During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers.
Rear thread adjustment block is mounted on the bottom.
Installation is also possible on vehicles equipped with NIVO / factory pneumatic suspension. In this case the assembly is possible only after the disassembly of the factory pneumatic system. In some cases, it may be necessary to use additional OEM Audi parts.
Een MTS schroefset met Eibach veren, geschikt voor de Audi A8 D2 4D2/4D8 2.8 / 3.7 / 2.5TDI
Street variant
De ophanging van de Street-serie is de standaardconfiguratie van MTS Technik-ingenieurs, het garandeert een breed scala aan verlagingen en een balans tussen comfort en stijfheid.
Verlaging voorzijde: van 10 tot 60 mm
Verlaging achterzijde: van 10 tot 30 mm
Maximaal belasting (voor):1380 kg
Maximaal belasting (achter):1230 kg
Geschikt voor:03/94 - 12/02
Let op:
Front and rear axle height adjustable (threaded shock absorber housing on the front, dampers, springs and height adjustable elements on the rear).
If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.
During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers.
Rear thread adjustment block is mounted on the bottom.
Installation is also possible on vehicles equipped with NIVO / factory pneumatic suspension. In this case the assembly is possible only after the disassembly of the factory pneumatic system. In some cases, it may be necessary to use additional OEM Audi parts.
